Cisco WAE-674-K9 Hardware Installation Guide - Page 61
clamps on the rear of the device to prevent the power cord from being
UPC - 882658200076
View all Cisco WAE-674-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Chapter 4 Installing Hardware Options for the WAE-7371, WAE-7341, and WAE-674 Replacing a Power Supply 6. Slide the replacement AC power supply into the bay until the retention latch clicks into place. 7. Connect the power cord for the new AC power supply to the power-cord connector on the power supply. 8. Route the power cord through the power-supply handle and through any cable clamps on the rear of the device to prevent the power cord from being accidentally pulled out when you slide the device in and out of the rack. 9. Connect the power cord to a properly grounded electrical outlet. 10. Make sure that the DC power LED and AC power LED on the power supply are lit, indicating that the power supply is operating correctly. OL-15012-02 Cisco Wide Area Application Engine 7341, 7371, and 674 Hardware Installation Guide 4-17