Home » Cisco Manuals » Wireless » Cisco WAP200E » Manual Viewer

Cisco WAP200E User Guide - Page 23

The Setup - Time Tab - default

UPC - 745883578597

Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

Wireless-G Access Point with Power Over Ethernet and Rangebooster • Subnet Mask. The Subnet Mask must be the same as that set on the LAN that your Access Point is connected to. The default is 255.255.255.0. • Default Gateway. Your ISP will provide you with the Default Gateway Address, which is the ISP server's IP address. • Primary DNS (Required) and Secondary DNS (Optional). Your ISP will provide you with at least one DNS (Domain Name System) Server IP Address. Select Automatic Configuration - DHCP if you have a DHCP server enabled on the LAN that can assign an IP address to the Access Point. Change these settings as described here and click Save Settings to apply your changes, or click Cancel Changes to cancel your changes. Help information is available on the right side of the screen. The Setup - Time Tab This allows you to change the Access Point's time settings. The correct time setting can help the administrator to search the system log to identify problems. Time You can set the time either manually or automatically from a time server if the Access Point can access the public Internet. Manually. Select this option to set the date and time manually. The default is to set the time manually. Automatically. Select this option and time zone. The Access Point will contact the public time server to get the current time. Automatically adjust clock for daylight saving changes. Select this option if you are in using the Access Point in a location that observes daylight saving time. User Defined NTP Server. Enable this option if you have set up local NTP server. Default is Disabled. NTP Server IP. Enter the IP address of user defined NTP Server. Change these settings as described here and click Save Settings to apply your changes, or click Cancel Changes to cancel your changes. Help information is available on the right side of the screen. Chapter 6: Configuring the Wireless-G Access Point The Setup - Time Tab Figure 6-2: Setup - Time 17

Section	Page
Copyright and Trademarks	2
How to Use this User Guide	2
Chapter 1: Introduction 1	3
Chapter 2: Planning Your Wireless Network 4	3
Chapter 3: Getting to Know the Wireless-G Access Point 7	3
Chapter 4: Connecting the Wireless-G Access Point 10	3
Chapter 5: Setting Up the Wireless-G Access Point 12	3
Chapter 6: Configuring the Wireless-G Access Point 16	3
Appendix A: Troubleshooting 43	4
Appendix B: Wireless Security 47	4
Appendix C: Upgrading Firmware 50	4
Appendix D: Windows Help 51	4
Appendix E: Glossary 52	4
Appendix F: Specifications 57	4
Appendix G: Warranty Information 60	4
Appendix H: Regulatory Information 61	4
Appendix I: Contact Information 68	4
List of Figures	5
Figure 2-1: Example of a Simple Wireless Network 6	5
Figure 3-1: Front Panel 7	5
Figure 3-2: Back View 8	5
Figure 3-3: Desktop Placement and Antenna Setup 9	5
Figure 4-1: Connect the Ethernet Cable 10	5
Figure 4-2: Connect the Power 10	5
Figure 4-3: Stand 11	5
Figure 4-4: Mounting Dimensions 11	5
Figure 5-1: Login Screen 13	5
Figure 6-1: Setup - Basic Setup 16	5
Figure 6-2: Setup - Time 17	5
Figure 6-3: Wireless - Basic Wireless Settings 18	5
Figure 6-4: Wireless - Wireless Security (Disabled) 19	5
Figure 6-5: Wireless - Wireless Security (WEP) 19	5
Figure 6-6: Wireless - Wireless Security (WPA-Personal) 20	5
Figure 6-7: Wireless - Wireless Security (WPA2-Personal) 20	5
Figure 6-8: Wireless - Wireless Security (WPA2-Personal Mixed) 21	5
Figure 6-9: Wireless - Wireless Security (WPA-Enterprise) 21	5
Figure 6-10: Wireless - Wireless Security (WPA2-Enterprise) 22	5
Figure 6-11: Wireless - Wireless Security (WPA2 - Enterprise Mixed) 22	5
Figure 6-12: Wireless - Wireless Security (RADIUS) 23	5
Figure 6-13: Wireless - Wireless Connection Control 24	5
Figure 6-14: Select MAC Address from Wireless Client List 24	5
Figure 6-15: Wireless - Advanced Wireless 25	5
Figure 6-16: Wireless - VLAN & QoS 26	5
Figure 6-17: AP Mode 28	5
Figure 6-18: Wireless Repeater Mode 29	5
Figure 6-19: Wireless Bridge Mode 30	5
Figure 6-20: Security Monitor - Basic Settings 31	6
Figure 6-21: Security Monitor - Event Log 32	6
Figure 6-22: Administration - Management 34	6
Figure 6-23: Administration - Log 36	6
Figure 6-24: Administration - Factory Default 37	6
Figure 6-25: Administration - Firmware Upgrade 37	6
Figure 6-26: Administration - Reboot 38	6
Figure 6-27: Administration - Config Management 38	6
Figure 6-28: Status - Local Network 39	6
Figure 6-29: Status - Wireless 40	6
Figure 6-30: Status - System Performance 41	6
Figure 6-31: Status - Wireless 41	6
Figure 6-32: Status - System Performance 41	6
Figure C-1: Firmware Upgrade 50	6
Chapter 1: Introduction	7
Welcome	7
What’s in this User Guide?	8
Chapter 2: Planning Your Wireless Network	10
Network Topology	10
Roaming	10
Network Layout	11
Example of a simple wireless network	12
Chapter 3: Getting to Know the Wireless-G Access Point	13
The LEDs	13
The Ports	14
Antennas and Positions	15
Chapter 4: Connecting the Wireless-G Access Point	16
Overview	16
Connection	16
Placement Options	17
Stand Option	17
Wall-Mount Option	17
Chapter 5: Setting Up the Wireless-G Access Point	18
Overview	18
Accessing the Utility	18
Navigating the Utility	19
Setup	19
Wireless	19
AP Mode	20
Security Monitor	20
Administration	20
Status	21
Chapter 6: Configuring the Wireless-G Access Point	22
The Setup - Basic Setup Tab	22
Basic Setup	22
Network Setup	22
The Setup - Time Tab	23
Time	23
The Wireless - Basic Wireless Settings Tab	24
Basic Settings	24
The Wireless - Wireless Security Tab	25
Wireless Security	25
The Wireless - Wireless Connection Control Tab	30
Wireless Connection Control	30
The Wireless - Advanced Wireless Settings Tab	31
Advanced Settings	31
The Wireless - VLAN & QoS Tab	32
The AP Mode Tab	34
AP Mode	34
The Security Monitor - Basic Settings Tab	37
The Security Monitor - Event Log Tab	38
The Administration - Management Tab	40
Management	40
Web Access	40
SNMP	41
The Administration - Log Tab	42
Log	42
The Administration - Factory Default Tab	43
Factory Default	43
The Administration - Firmware Upgrade Tab	43
Firmware Upgrade	43
The Administration - Reboot Tab	44
Reboot	44
The Administration - Config Management Tab	44
Config Management	44
The Status - Local Network Tab	45
Information	45
Local Network	45
The Status - Wireless Tab	46
Wireless Network	46
The Status - System Performance Tab	47
System Performance	47
Appendix A: Troubleshooting	49
Frequently Asked Questions	49
Appendix B: Wireless Security	53
Security Precautions	53
Security Threats Facing Wireless Networks	53
Appendix C: Upgrading Firmware	56
Appendix D: Windows Help	57
TCP/IP	57
Shared Resources	57
Network Neighborhood/My Network Places	57
Appendix E: Glossary	58
Appendix F: Specifications	63
Appendix G: Warranty Information	66
Appendix H: Regulatory Information	67