Cisco WS-C2950-24 Hardware Installation Guide - Page 203
Installing a FIPS Louver
View all Cisco WS-C2950-24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 203 highlights
Chapter 5 Installing and Upgrading Internal Modules and FRUs Installing a FIPS Louver Installing a FIPS Louver A Federal Information Processing Standards (FIPS) louver can be installed to make a Cisco 2911 system compliant with FIPS 140-2. Complete the following steps to install the louver. Step 1 Step 2 Step 3 Read the "Safety Warnings" section on page 5-2 section and disconnect the power supply before you perform any module replacement. Remove the screws to gain access to the side of the router as shown in Figure 5-40. Insert the four 8-32 screws through the FIPS louver plate, then position the FIPS spacers over the screws. See Figure 5-40. Figure 5-40 FIPS Louver Components and Installation) 3 252937 Cisco 2900 Series 1 Screws 3 FIPS louver spacer 3 2 FIPS louver Step 4 Tighten the screws to secure the louver and spacers onto the router. Figure 5-41 Properly Installed FIPS Louver 1 1 2 Cisco 2900 Series 252938 OL-18712-03 Cisco 2900 Series and 3900 Series Hardware Installation Guide 5-51