Compaq DC7600 HP Compaq dx 7200 and dc7600 Personal Computers, Technical Refer - Page 86
SATA Connector, SATA Bus Master Control Registers
UPC - 882780682009
View all Compaq DC7600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
Input/Output Interfaces SATA Bus Master Control Registers The SATA interface can perform PCI bus master operations using the registers listed in Table 5-5. These registers occupy 16 bytes of variable I/O space set by software and indicated by PCI configuration register 20h in the previous table. As indicated, these registers are virtually a copy of those used by EIDE operations discussed in the EIDE section. I/O Addr. Offset 00h 02h 04h 08h 0Ah 0Ch Table 5-5. IDE Bus Master Control Registers Size (Bytes) Register 1 Bus Master IDE Command (Primary) 1 Bus Master IDE Status (Primary) 4 Bus Master IDE Descriptor Pointer (Primary) 1 Bus Master IDE Command (Secondary) 2 Bus Master IDE Status (Secondary) 4 Bus Master IDE Descriptor Pointer (Secondary Default Value 00h 00h 0000 0000h 00h 00h 0000 0000h SATA Connector The 7-pin SATA connector is shown in the figure below. Pin 1 Pin 7 A B Figure 5-2. 7-Pin SATA Connector (on system board). Table 5-6. 7-Pin SATA Connector Pinout Pin Description Pin Description 1 Ground 6 RX positive 2 TX positive 7 Ground 3 TX negative A Holding clip 4 Ground B Holding clip 5 RX negative -- -- 5-6 www.hp.com Technical Reference Guide