Compaq DC7600 HP Compaq dx 7200 and dc7600 Personal Computers, Technical Refer - Page 89
Diskette Drive Interface Control, Table 5-8.
UPC - 882780682009
View all Compaq DC7600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
Input/Output Interfaces Diskette Drive Interface Control The BIOS function INT 13 provides basic control of the diskette drive interface. The diskette drive interface can be controlled by software through the SCH5307's I/O-mapped registers listed in Table 5-8. The diskette drive controller of the SCH5307 operates in the PC/AT mode in these systems. Table 5-8. Diskette Drive Interface Control Registers Primary Second. Address Address Register 3F0h 370h Status Register A: Interrupt pending Reserved (always 1) STEP pin status (active high) TRK 0 status (active high) HDSEL status (0 = side 0, 1 = side 1) INDEX status (active high) WR PRTK status (0 = disk is write protected) Direction (0 = outward, 1 = inward) 3F1h 371h Status Register B: Reserved (always 1's) DOR bit 0 status Write data toggle Read data toggle WGATE status (active high) MTR 2, 1 ON- status (active high) 3F2h 372h Digital Output Register (DOR): Reserved Motor 1, 0 enable (active high) DMA enable (active high) Reset (active low) Drive select (00 = Drive 1, 01 = Drive 2, 10 = Reserved, 11 = Tape drive) 3F3h 373h Tape Drive Register (available for compatibility) R/W R R R/W R/W Technical Reference Guide www.hp.com 5-9