Compaq ML310 User Guide - Page 66
Configuring the SATA RAID feature
![]() |
UPC - 613326264973
View all Compaq ML310 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
66 HP ProLiant ML310 Generation 3 Server User Guide Configuring the SATA RAID feature CAUTION: Back up any data stored on the hard drives before proceeding. The configuration process erases all data on the hard drives. 1. Power up the server. Press the F9 key to launch RBSU. NOTE: Enabling the RAID option in RBSU is only necessary for installation of the RAID driver. If this option is not enabled, the OS loads the standard ATA driver from the OS media. 2. Select Advanced Options>SATA Software RAID>Enable RAID. 3. Press the F10 key twice to exit RBSU. The system automatically reboots. 4. After the system reboots, press the F8 key to activate the embedded SATA RAID controller. 5. Select Array Configuration Utility from the Option menu. 6. Select Configure Drives from the main menu. 7. Press the INS key twice to select the two SATA drives. 8. Press the Enter key to complete selection. The system prompts a selection of RAID 0 or RAID 1. 9. Select a RAID level. 10. Enter an Array Label. If RAID 0 is selected, select a Stripe Size. 11. Select Create RAID: RAID options RAID 0 RAID 0 RAID 1 RAID 1 RAID 1 Description No Init - Creates array without initialization Migrate* - Creates RAID 0 from a single drive Quick Init - Creates array without initialization Clear* - Writes zeroes to all the array members Build* - Copies data from source drive to target drive. *The process can take 30 minutes or more to complete depending on the drive capacity. 12. After the configuration is complete, select Done.
![](/manual_guide/products/compaq-ml310-user-guide-69993ce/66.png)