D-Link DES-3326S Reference Manual - Page 117
config syslog host
UPC - 790069242755
View all D-Link DES-3326S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
DES-3326SR Layer 3 Fast Ethernet Switch CLI Reference Manual To create syslog host: DES-3326SR:4#create syslog host 1 severity all facility local0 Command: create syslog host 1 severity all facility local0 Success. DES-3326SR:4# config syslog host Purpose Used to configure the syslog protocol to send system log data to a remote host. Syntax config syslog host [all/] {severity [i nf o rm at i o nal/warni ng/all]/ f ac i li t y [lo c al0/lo c al1/lo c al2/lo c al3/ lo c al4/lo c al5/lo c al6/lo c al7]/udp_po rt / ipaddress / state[enabled/disabled] Description The config syslog host command is used to configure the syslog protocol to send system log information to a remote host. Parameters all − Specifies that the command will be applied to all hosts. − Specifies that the command will be applied to an index of hosts. There are four available indexes, numbered 1 through 4. severity − Severity level indicator. These are described in the following: Bold font indicates that the Network Monitoring Commands 117