D-Link DES-3326S Reference Manual - Page 335
config ospf virtual_link
UPC - 790069242755
View all D-Link DES-3326S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 335 highlights
DES-3326SR Layer 3 Fast Ethernet Switch CLI Reference Manual config ospf virtual_link Purpose Used to configure the OSPF virtual interface settings. Syntax config ospf virtual_link {hello_interval /de ad_i nt e rv al /authentication [simple /md5 /none]} Description This command is used to configure the OSPF virtual interface settings. Parameters − A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the OSPF domain. − The OSPF router ID for the remote area. This is a 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies the remote area's Area Border Router. hello_interval − Allows the specification of the interval between the transmission of OSPF Hello packets, in seconds. Between 5 and 65535 seconds can be specified. The Hello Interval, Dead Interval, Authorization Type, and Authorization Key should be the same for all routers on the same network. dead_interval − Allows the specification of the length of time between OSPF Configuration Commands 335