D-Link DES-3326S Reference Manual - Page 127
config stp ports
UPC - 790069242755
View all D-Link DES-3326S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
DES-3326SR Layer 3 Fast Ethernet Switch CLI Reference Manual config stp ports Purpose Used to setup STP on the port level. Syntax config stp ports {cost /priority / migrate [yes/no]/ edge [true/false]/ p2p [true/false]/ state [enabled/disabled] Description This command is used to create and configure STP for a group of ports. Parameters cost − This defines a metric that indicates the relative cost of forwarding packets to the specified port list. The default cost for a 1000 Mbps port is 4, a 100 Mbps port is 19, and for a 10 Mbps port the default cost is 100. priority − A numeric value between 0 and 31 that is used in determining the root and designated port in an STP port list. The default is 16, with 0 indicating the highest priority. − Specifies a range of ports to be configured. The port list is specified by listing the lowest switch number and the beginning port number on that switch, separated by a colon. Then highest switch number, and the highest port number of the range (also separated by a colon) are specified. The beginning and end of the port list range are separated by a dash. For example, 1:3 would specify switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and switch 2, port − Spanning Tree Commands 127