D-Link DFL-2500 User Guide - Page 250
Specify any eventual NBNS WINS
View all D-Link DFL-2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 250 highlights
22.2. PPTP/ L2TP 231 3. PPTP Server Next step is to configure the PPTP server. Interfaces → L2TP/PPTP Servers → Add → L2TP/PPTP Server: Enter the following: Name: PPTPServer Inner IP Address: This is the IP address of the PPTP server inside the tunnel. In this case 192.168.1.1 Tunnel Protocol: PPTP Outer Interface Filter: WAN Server IP: This is the IP that remote users will connect to, in this case 10.0.0.1 Use User Authentication Rules: Enable (Specifies that authentication should be performed) Microsoft Point-to-Point Encryption (MPPE): Select the encryption strengths to allow. IP Pool: 192.168.1.10-192.168.1.20 (The pool of IP addresses to assign IP:s from to connecting users) DNS (Primary/Secondary): Specify any eventual DNS servers to hand out to connected clients. NBNS (Primary/Secondary): Specify any eventual NBNS (WINS) servers to hand out to connected clients. Proxy ARP: Leave as default, or specifically select the LAN interface if the IP:s in the IP Pool are a part of the network on the LAN interface. Then click OK D-Link Firewalls User's Guide