D-Link DGS-3630-28SC Quick installation Guide - Page 260
Route Preference, L3 Features > Route Preference
![]() |
View all D-Link DGS-3630-28SC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 260 highlights
DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide The fields that can be configured are described below: Parameter IPv6 Address IPv6 Address/Prefix Length Interface Name Connected RIPng OSPFv3 ISIS BGP Database Hardware Summary Description Select and enter the IPv6 address to display here. Select and enter the IPv6 address and prefix length to display here. Select the Longer Prefixes option to display IPv6 routes with prefixes greater than and equal to the prefix length. Select and enter the name of the interface to display here. Select this option to display only connected routes. Select this option to display only RIPng routes. Select this option to display only OSPFv3 routes. Select this option to display only ISIS routes. Select this option to display only BGP routes. Select this option to display all the related entries in the routing database instead of just the best route. Select this option to display only hardware routes. Hardware routes are routes that have been written into the hardware chip. Select this option to display a summary and count of the route sources configured on this Switch. Click the Find button to locate a specific entry based on the information entered. Enter a page number and click the Go button to navigate to a specific page when multiple pages exist. Route Preference This window is used to display and configure the route preference settings. Use this window to configure the distance, which represents the route's trust rating. The route with a lower distance value is preferred over the route with a higher distance value. To view the following window, click L3 Features > Route Preference, as shown below: Figure 6-27 Route Preference Window The fields that can be configured are described below: Parameter VRF Name Distance Default Distance Static Description Enter the name of the VRF instance here. This name can be up to 12 characters long. Click the Please Select button to select a pre-configured VRF instance that will be used here. Enter the administrative distance of default routes here. The range is from 1 to 255. By default, this value is 1. Enter the administrative distance of static default routes here. The range is from 1 to 255. By default, this value is 60. 248
![](/manual_guide/products/dlink-dgs363028sc-quick-installation-guide-26b84e6/260.png)