D-Link DGS-3630-28SC Quick installation Guide - Page 344
PIM for IPv6 Register Settings
View all D-Link DGS-3630-28SC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 344 highlights
DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide Parameter Description • Embedded RP - Specifies to display group ranges learned through the embedded rendezvous point (RP). • Static - Specifies to display ranges enabled by static configuration. Click the Find button to locate a specific entry based on the information entered. Click the Show All button to display all the entries. Enter a page number and click the Go button to navigate to a specific page when multiple pages exist. PIM for IPv6 Register Settings This window is used to display and configure the IPv6 PIM register settings. To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv6 > PIM for IPv6 Register Settings, as shown below: Figure 6-132 PIM for IPv6 Register Settings Window The fields that can be configured in Register Checksum Wholepkt are described below: Parameter Register Checksum Wholepkt Description Select the enable or disable the register checksum whole-packet feature here. When enabled, it configures the router to calculate the checksum of register message over the entire PIM message including the data portion. By default, the register checksum methodology is PIM RFC-compliant, excluding the data portion in the Register message. Click the Apply button to accept the changes made. The fields that can be configured in Register Probe Time are described below: Parameter Register Probe Description Enter the register probe time value here. The range is from 1 to 127 seconds. The register-probe time is the time before the Register-Stop Timer (RST) expires when a DR may send a Null-Register to the RP to cause it to resend a RegisterStop message. Select the Default option to use the default value, which is 5 seconds. Click the Apply button to accept the changes made. The fields that can be configured in Register Suppression Time are described below: Parameter Register Suppression Description Enter the register suppression timeout value here. The range is from 3 to 65535 332