D-Link DIR-2680-US User Manual - Page 63
Network continued
![]() |
View all D-Link DIR-2680-US manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Section 4 - Configuration Network (continued) DHCP Server Status: Enable or disable the DHCP server. DHCP IP Address Enter the starting and ending IP addresses for the DHCP server's IP Range: assignment. Note: If you statically (manually) assign IP addresses to your computers or devices, make sure the IP addresses are outside of this range or you may have an IP conflict. DHCP Lease Time: Enter the length of time for the IP address lease in minutes. Always Broadcast: Enable this feature to broadcast your network's DHCP server to LAN/ WLAN clients. Advanced Settings WAN Port Speed: You may set the port speed of the Internet port to 10 Mbps, 100 Mbps, 1000 Mbps, or Auto (recommended). UPnP: Enable or disable Universal Plug and Play (UPnP). UPnP provides compatibility with networking equipment, software, and peripherals. IPv4 Multicast Enable to allow IPv4 multicast traffic to pass through the router from Stream: the Internet. IPv6 Multicast Enable to allow IPv6 multicast traffic to pass through the router from Stream: the Internet. Click Save when you are done. D-Link DIR-2680 User Manual 59
![](/manual_guide/products/dlink-dir2680us-user-manual-fb013b4/63.png)