D-Link DSN-1100-10 Hardware Reference Guide for DSN-1100-10 Valid for fir - Page 40

Replacing a Power Supply

Get D-Link DSN-1100-10 - xStack Storage Area Network Array Hard Drive PDF manuals and user guides
UPC - 790069321559
View all D-Link DSN-1100-10 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 40 highlights

A.4 Replacing a Power Supply The DSN-1100 xStack Storage Array contains one user replaceable power supply. It can be replaced as follows. To replace the power supply, use the following procedure. 1. Power down the DSN-1100 storage system and remove the power cord from the back panel. 2. Attach an ESD-preventive wrist strap. 3. Open the enclosure to access the DSN-1100 storage system controller (see section A.1). 4. Remove the two screws shown in Figure A-24 found on the rear of the chassis. Screw Screw Figure A-24 Remove These Two Screws on the Rear of the Chassis 40 Appendix A Replacing and Upgrading FRUs

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
40
Appendix A Replacing and Upgrading FRUs
A.4
Replacing a Power Supply
The DSN-1100 xStack Storage Array contains one user replaceable power supply.
It can be
replaced as follows.
To replace the power supply, use the following procedure.
1.
Power down the DSN-1100 storage system and remove the power cord from the back
panel.
2.
Attach an ESD-preventive wrist strap.
3.
Open the enclosure to access the DSN-1100 storage system controller (see section A.1).
4.
Remove the two screws shown in Figure A-24 found on the rear of the chassis.
Figure A-24
Remove These Two Screws on the Rear of the Chassis
Screw
Screw