Dell 8 Web Tools Administrator’s Guide - Page 251

DRAFT: BROCADE CONFIDENTIAL SNMP configuration 17 3. Enter a contact name, description, and location in the SNMP Information section. 4. Optional: Select the Enable Authentication Trap check box to allow authentication traps to be sent to the reception IP address. 5. Click Apply. Setting SNMPv1 configuration parameters Use the following procedure to set SNMPv1 configuration parameters. 1. Open the Switch Administration window as described in "Opening the Switch Administration window" on page 35. 2. Select the SNMP tab. 3. Double-click a community string in the SNMPv1 section and enter a new community string. 4. Double-click a recipient IP address in the SNMPv1 section and enter a new IP address. 5. Click Apply. Setting SNMPv3 configuration parameters NOTE The port number is not included. Use the following procedure to set SNMPv3 configuration parameters. 1. Open the Switch Administration window as described in "Opening the Switch Administration window" on page 35. 2. Select the SNMP tab. 3. Select a user name from the User Name menu in the SNMPv3 section. NOTE The list is scrollable. If you do not see your user name, scroll down using the scroll bar or by clicking the User Name heading. 4. Double-click a recipient IP address in the SNMPv3 section and enter a new IP address. 5. Select a trap level from the Trap Level menu. 6. Optional: Select the Enable SNMPv3 Informs for all Trap Recipients check box to enable or disable inform requests for all trap recipients. 7. Enabling SNMPv3 informs allows you to enter the Engine ID. The Engine ID is required to authenticate the inform request. If informs request is disabled, the SNMP manager does not send a response to the sender. 8. Click Apply. Web Tools Administrator's Guide 223 53-1001772-01