Dell 810 Owners Manual - Page 87
Installing a Hard-Drive Blank, Removing a Hard-Drive Carrier, Removing the Front Bezel
View all Dell 810 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
Figure 3-4. Removing or Installing a Hard-Drive Blank 1 2 1 hard-drive blank 2 release button Installing a Hard-Drive Blank 1 If installed, remove the front bezel. See "Removing the Front Bezel" on page 83. 2 Insert the drive blank into the drive bay until the release button clicks into place. 3 If applicable, install the front bezel. See "Installing the Front Bezel" on page 83. Removing a Hard-Drive Carrier CAUTION: Ensure that your operating system supports hot-swap drive installation. See the documentation supplied with the operating system. 1 If installed, remove the front bezel. See "Removing the Front Bezel" on page 83. 2 From the management software, prepare the drive for removal. Wait until the hard-drive indicators on the drive carrier signal that the drive can be removed safely. See your controller documentation for information about hot-swap drive removal. Installing System Components 87