Dell Alienware m16 R1 Service Manual - Page 67
Installing the palm-rest and keyboard assembly
![]() |
View all Dell Alienware m16 R1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Steps After performing the pre-requisites you are left with the palm-rest and keyboard assembly. NOTE: Ensure that the solid-state drive mounts on slot one and two are removed from the old palm-rest and keyboard assembly before installing the new palm-rest and keyboard assembly. These solid-state drive mounts will be installed into the new palm-rest and keyboard assembly. Installing the palm-rest and keyboard assembly Prerequisites If you are replacing a component, remove the existing component before performing the installation process. About this task The following image(s) indicate the location of the palm-rest and keyboard assembly and provides a visual representation of the installation procedure. Steps Place the palm-rest and keyboard assembly on a flat and clean surface and perform the post-requisites to install the palm-rest and keyboard assembly. NOTE: Install the solid-state drive mounts on the slots from the old palm-rest and keyboard assembly into the new palm-rest and keyboard assembly. Next steps 1. Install the power button. 2. Follow the procedure from step 5 to step 13 in Installing the system board. 3. Install the keyboard-controller board. 4. Install the display assembly. 67
![](/manual_guide/products/dell-alienware-m16-r1-service-manual-254db5c/67.png)