Home » Dell Manuals » Servers » Dell Force10 S5000 » Manual Viewer

Dell Force10 S5000 Getting Started Guide - Page 36

Meets Bellcore Zone 4 earthquake requirements, 48V ~ -60V VDC

Add to My Manuals
Save this manual to your list of manuals

Page 36 highlights

Parameter Maximum thermal output Maximum Altitude Shock Table 9. Power Requirements Parameter AC Power supply DC Power supply Maximum current draw per system Maximum power consumption Specifications 2388 BTU/hr No performance degradation to 6600 ft Meets Bellcore Zone 4 earthquake requirements Specifications 100 VAC ~ 240 VAC 50/60 Hz -48V ~ -60V VDC 7 A @ 100 VAC 3.5 A @ 200 VAC 700 Watts 36

Section	Page
Getting Started Guide	3
Introduction	3
Product Description	3
Unpacking the Switch	3
Important Points Before You Continue	4
Hardware Installation Overview	5
Hardware Overview	5
I/O Panel	5
Utility Panel	6
Port Numbering Convention	7
System Status	7
Installation	11
Install the S5000 Chassis in a Rack or Cabinet	12
Attaching the Mounting Brackets	12
Rack Mounting Safety Considerations	13
Installing the S5000 Chassis into a 4-Post Rack or Cabinet	13
Rack Grounding	14
Important Points to Remember for Installing an Ethernet Module	14
Installing an Ethernet Module	15
Important Points to Remember for Installing a Fibre Channel Module	16
Installing a Fibre Channel Module	17
Important Points to Remember for Installing an AC Power Supply	18
Installing an AC Power Supply	19
Assembling and Connecting the Safety Ground Wire for DC Power Supply	20
Important Points to Remember for Installing a DC Power Supply	21
Installing a DC Power Supply	22
Installing the Ferrite Bead for DC Power and Return Cables	23
Securing Power Cables	24
Important Points to Remember for Installing a Fan Module	25
Installing a Fan Module	25
Installing the SFP+ and QSFP+ Optics	26
Splitting QSFP+ Ports to SFP+ Ports	26
Supplying Power and Powering Up the System	27
Performing the Initial Configuration	28
Software Configuration Overview	28
Accessing the RJ-45/RS-232 Console Port	28
Accessing the RJ-45 Console Port with a DB-9 Adapter	29
Accessing the USB-B Console Port	29
Enter the Initial Configuration Information	30
Configuring the Enable Password	31
Configuring a Host Name	31
Navigate CLI modes	32
Default Configuration	32
Configuring Layer 2 (Data Link) Mode	32
Accessing the System Remotely	32
Configuring the Management Port IP Address	32
Configuring a Management Route	33
Configuring a Username and Password	33
Creating a Port-based VLAN	33
Assigning Interfaces to a VLAN	34
Assigning an IP Address to a VLAN	34
Connecting the S5000 to the Network	35