Dell Force10 S55T Quick Start Guide - Page 7

1 Installing the Hardware This guide assumes all site preparation has been performed before installing the chassis. Installing the Chassis in a Rack or Cabinet To install the S55 or S60 systems, Dell Force10 recommends that you complete the installation procedures in the order presented below. NOTE: Unless stated otherwise, the installation instructions below apply to both the S55 and S60 chassis. Always handle the system and its components with care. Avoid dropping the switch or its field replaceable units. CAUTION: Always wear an ESD-preventive wrist or heel ground strap when handling the chassis and its components. As with all electrical devices of this type, take all necessary safety precautions to prevent injury when installing this system. Electrostatic discharge (ESD) damage can occur if components are mishandled. Attaching Mounting Brackets The chassis is shipped with mounting brackets (rack ears) and required screws for rack or cabinet installation. The brackets are enclosed in a package with the chassis. NOTE: Dell Force10 recommends attaching the brackets at the PSU side. This provides the greatest weight support for the chassis in the rack or cabinet. . Step Task 1 Take the brackets and screws out of their packaging. Installing the Hardware 5