Dell GX280DT User Guide - Page 248
floppy-drive connector DSKT
UPC - 851846002006
View all Dell GX280DT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 248 highlights
3. Press inward on the two tabs on the sides of the drive, slide the drive upward, and remove it from the floppy-drive bay. Installing a Floppy Drive 1. If you are replacing a drive and the new drive does not have the bracket rails attached, remove the rails from the old drive by removing the two screws that secure each rail to the drive. Attach the bracket to the new drive by aligning the screw holes on the drive with the screw holes on the bracket rails and then inserting and tightening all four screws (two screws on each rail). 1 drive 2 bracket rails (2) 3 screws (4) 2. Gently slide the drive into place until you hear a click or feel the drive securely installed. 3. Attach the power and floppy-drive cables to the floppy drive. 4. Connect the other end of the floppy-drive cable to the connector labeled "DSKT" on the system board. 1 power cable 2 floppy-drive cable 3 floppy-drive connector (DSKT)