Dell Inspiron 13 N3010 Service Manual - Page 15

Back to Contents

Get Dell Inspiron 13 N3010 PDF manuals and user guides View all Dell Inspiron 13 N3010 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

NOTE: This procedure assumes that you have already removed the processor heat sink fan and are ready to replace it. 1. Follow the instructions in Before You Begin. 2. Place the processor heat sink fan in position and replace the screw that secures the processor heat sink fan to the computer base. 3. Connect the processor heat sink fan cable to the connector on the system board. 4. Slide the VGA connector cable to the connector on the system board, and press down on the connector latch to secure the cable. 5. Replace the palm rest assembly (see Replacing the Palm Rest Assembly). 6. Replace the keyboard (see Replacing the Keyboard). 7. Replace the memory module(s) (see Replacing the Memory Module(s)). 8. Replace the memory-module cover (see Replacing the Memory-Module Cover). 9. Replace the battery (see Replacing the Battery). CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in damage to the computer. Back to Contents Page

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
1.
Follow the instructions in
Before You Begin
.
2.
Place the processor heat sink fan in position and replace the screw that secures the processor heat sink fan to the computer base.
3.
Connect the processor heat sink fan cable to the connector on the system board.
4.
Slide the VGA connector cable to the connector on the system board, and press down on the connector latch to secure the cable.
5.
Replace the palm rest assembly (see
Replacing the Palm Rest Assembly
).
6.
Replace the keyboard (see
Replacing the Keyboard
).
7.
Replace the memory module(s) (see
Replacing the Memory Module(s)
).
8.
Replace the memory-module cover (see
Replacing the Memory
-
Module Cover
).
9.
Replace the battery (see
Replacing the Battery
).
Back to Contents Page
NOTE:
This procedure assumes that you have already removed the processor heat sink fan and are ready to replace it.
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.