Dell Inspiron 13 N3010 Service Manual - Page 22

Display Cable

Page 22 highlights

1 screws (4) 2 display panel brackets (2) 6. Remove the display panel brackets off the display panel. Replacing the Display Panel Bracket 1. Follow the instructions in Before You Begin. 2. Place the display panel brackets in position. 3. Replace the four screws (two on each side) that secure the display panel brackets to the display panel. 4. Replace the display panel (see Replacing the Display Panel). 5. Replace the display bezel (see Replacing the Display Bezel). 6. Replace the display assembly (see Replacing the Display Assembly). CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in damage to the computer. Display Cable Removing the Display Cable 1. Follow the instructions in Before You Begin. 2. Remove the display assembly (see Removing the Display Assembly). 3. Remove the display bezel (see Removing the Display Bezel). 4. Remove the display panel (see Removing the Display Panel). 5. Turn the display panel over and place it on a clean surface. 6. Remove the camera module (see Removing the Camera Module). 7. Peel the tape on the display cable and disconnect the display cable from the connector on the display panel. 8. Remove the display cable off the display panel.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48

6.
Remove the display panel brackets off the display panel.
Replacing the Display Panel Bracket
1.
Follow the instructions in
Before You Begin
.
2.
Place the display panel brackets in position.
3.
Replace the four screws (two on each side) that secure the display panel brackets to the display panel.
4.
Replace the display panel (see
Replacing the Display Panel
).
5.
Replace the display bezel (see
Replacing the Display Bezel
).
6.
Replace the display assembly (see
Replacing the Display Assembly
).
Display Cable
Removing the Display Cable
1.
Follow the instructions in
Before You Begin
.
2.
Remove the display assembly (see
Removing the Display Assembly
).
3.
Remove the display bezel (see
Removing the Display Bezel
).
4.
Remove the display panel (see
Removing the Display Panel
).
5.
Turn the display panel over and place it on a clean surface.
6.
Remove the camera module (see
Removing the Camera Module
).
7.
Peel the tape on the display cable and disconnect the display cable from the connector on the display panel.
8.
Remove the display cable off the display panel.
1
screws (4)
2
display panel brackets (2)
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.