Dell Inspiron 16 5630 Service Manual - Page 57
Installing the palm-rest and keyboard assembly
![]() |
View all Dell Inspiron 16 5630 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
1. Follow the procedure in Before working inside your computer. 2. Remove the base cover. 3. Remove the fan. 4. Remove the wireless card. 5. Remove the M.2 2230 solid-state drive or M.2 2280 solid-state drive, whichever applicable. 6. Remove the battery. 7. Remove the speakers. 8. Remove the coin-cell battery. 9. Remove the I/O board. 10. Remove the power button or power button with fingerprint reader, whichever applicable. 11. Remove the power-adapter port. 12. Remove the display assembly. 13. Remove the system board. 14. Remove the touchpad. About this task NOTE: Before removing the base cover, ensure that there is no SD card installed in the SD card slot on your computer. NOTE: The system board can be removed and installed along with the heat sink, when you replace the palm-rest and keyboard assembly. This simplifies the removal and installation procedure and also prevents damage to the thermal bond between the system board and heat sink. The following image(s) indicate the location of the palm-rest and keyboard assembly and provides a visual representation of the removal procedure. Steps After performing the pre-requisites, you are left with the palm-rest and keyboard assembly. Installing the palm-rest and keyboard assembly Prerequisites CAUTION: The information in this section is intended for authorized service technicians only. Removing and installing components 57
![](/manual_guide/products/dell-inspiron-16-5630-service-manual-1fb1a5c/57.png)