Dell Inspiron 16 7610 Service Manual for computers with three fans - Page 22
Removing the M.2 2280 solid-state drive, Prerequisites, About this task, Steps
![]() |
View all Dell Inspiron 16 7610 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
2. Exit Service Mode. 3. Follow the procedure in After working inside your computer. Removing the M.2 2280 solid-state drive Prerequisites 1. Follow the procedure in Before working inside your computer. 2. Enter Service Mode. 3. Remove the base cover. About this task NOTE: This procedure applies only to computers shipped with an M.2 2280 solid-state drive installed in M.2 slot one. NOTE: The M.2 card installed on M.2 slot one will depend on the configuration ordered. Supported card configurations on the M.2 card slot: ● M.2 2230 solid-state drive + M.2 2230 mounting bracket ● M.2 2280 solid-state drive The following image(s) indicate the location of the M.2 2280 solid-state drive and provides a visual representation of the removal procedure. Steps 1. Remove the screw (M2x3) that secures the M.2 thermal shield to the system board. 2. Slide and lift the M.2 thermal shield from the M.2 card slot on the system board. 3. Slide and lift the M.2 2280 solid-state drive from the M.2 card slot on the system board. Installing the M.2 2280 solid-state drive Prerequisites If you are replacing a component, remove the existing component before performing the installation process. 22 Removing and installing components
![](/manual_guide/products/dell-inspiron-16-7610-service-manual-computers-fans-fb3c8e3/22.png)