Dell Inspiron 16 7610 Service Manual for computers with three fans - Page 50

Installing the power-button with fingerprint reader

Get Dell Inspiron 16 7610 PDF manuals and user guides View all Dell Inspiron 16 7610 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 50 highlights

Installing the power-button with fingerprint reader Prerequisites If you are replacing a component, remove the existing component before performing the installation process. About this task The following image(s) indicate the location of the power-button with fingerprint reader and provides a visual representation of the installation procedure. Steps 1. Using the alignment posts, place the power-button with fingerprint reader into its slot on the palm-rest and keyboard assembly. 2. Replace the screw (M2x3) that secures the power-button with fingerprint reader to the palm-rest and keyboard assembly. Next steps 1. Install the power-button board. 2. Install the heat sink. 3. Install the left fan. 4. Install the base cover. 5. Exit Service Mode. 6. Follow the procedure in After working inside your computer. 50 Removing and installing components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
Installing the power-button with fingerprint reader
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the power-button with fingerprint reader and provides a visual representation of
the installation procedure.
Steps
1.
Using the alignment posts, place the power-button with fingerprint reader into its slot on the palm-rest and keyboard
assembly.
2.
Replace the screw (M2x3) that secures the power-button with fingerprint reader to the palm-rest and keyboard assembly.
Next steps
1.
Install the
power-button board
.
2.
Install the
heat sink
.
3.
Install the
left fan
.
4.
Install the
base cover
.
5.
Exit
Service Mode
.
6.
Follow the procedure in
After working inside your computer
.
50
Removing and installing components