Dell Inspiron 3200 Service Manual - Page 84
Processor Board, When reinstalling the Inspiron M166ST, M200ST, M233ST, or M233XT pro
View all Dell Inspiron 3200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Processor Board processor board main board rubber bumper connector JP18 connector JP19 Figure 4-31. Processor Board Removal Remove the processor board from the main board. The processor board is held in place on the main board by connectors JP18 and JP19. Using the fingers of one hand, gently remove the processor board from the main board by pulling straight up. Do not rock the processor board to remove it. This may damage the two connectors on the processor board or the main board. There is a rubber bumper on the upper right corner of the processor board. The bumper assists in keeping the processor board in place. If you install a replacement processor board, be sure to apply a bumper in that corner of the processor board. Also, there is heat-sink thermal pad on top of the microprocessor and this may need to be reinstalled. When reinstalling the Inspiron M166ST, M200ST, M233ST, or M233XT processor board, press down on the white dot on top of the board. The white dot indicates the best spot to apply pressure to seat the processor correctly on connectors JP18 and JP19. (White dot references on the Inspiron D233ST, D233XT, and D266XT processor boards are not necessary.) 4-48 Dell Inspiron 3000 Series Service Manual