Dell Latitude 7340 Service Manual - Page 20
Installing the M.2 2230 solid-state drive, About this task, Steps, Prerequisites
View all Dell Latitude 7340 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
NOTE: To avoid data loss, do not remove the solid-state drive while the computer is in sleep or on state. 2. Remove the base cover. About this task NOTE: The M.2 card that is installed on your computer depends on the configuration ordered. Supported card configurations on the M.2 card slot are: ● M.2 2230 solid-state drive The following image indicates the location of the M.2 2230 solid-state drive and provides a visual representation of the removal procedure. Steps 1. Remove the single screw (M2x3) to open the M.2 SSD shielding cover from the system board. 2. Remove the single screw (M2x4) that secure the M.2 2230 solid-state drive extension thermal plate to the system board. 3. Using a flat-headed tool, pry open the M.2 SSD shielding cover from the recess on its bottom side and remove it from the system board. 4. Slide and remove the M.2 2230 solid-state drive from the M.2 card slot on the system board. NOTE: For computers shipped without a solid-state drive thermal plate, a thermal pad sticker is adhered to the system board underneath the solid-state drive. If in the process of replacing the solid-state drive, the thermal pad is separated from the plate or gets adhered to the solid-state drive, readhere the thermal pad to the system board before reinstalling the solid-state drive to the system. Installing the M.2 2230 solid-state drive Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following image indicates the location of the M.2 2230 solid-state drive and provides a visual representation of the installation procedure. 20 Removing and installing components