Dell N3200-ON PowerSwitch N3200-ON/E3200-ON Series Installation Guide - Page 46

Wall or ceiling installation

Get Dell N3200-ON PDF manuals and user guides View all Dell N3200-ON manuals
Add to My Manuals
Save this manual to your list of manuals

Page 46 highlights

4. Install the AC power cable to the EPA and secure with the wire clip. 5. Bend the AC power cable 180 degrees along the holder wall and through the cable cutout. 6. Secure the wire clip over the EPA cable. Wall or ceiling installation To install a single EPA power adapter holder on a wall or ceiling: NOTE: This installation instruction procedure applies to the external power adapter. You must order the mounting supplies for this installation separately. You need a drill and a pencil to complete this procedure. 1. Install the EPA in the power adapter holder using Steps 1 through 3 in the Power adapter holder assembly section. 2. Hold the EPA power adapter assembly to the wall or ceiling. Mark the screw-hole locations on the wall or ceiling with the pencil. 3. Drill four holes in the wall or ceiling at the pencil marks. 4. Screw the power adapter holder assembly to the wall or ceiling using four screws. Ceiling mount 46 External power adapter

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
4.
Install the AC power cable to the EPA and secure with the wire clip.
5.
Bend the AC power cable 180 degrees along the holder wall and through the cable cutout.
6.
Secure the wire clip over the EPA cable.
Wall or ceiling installation
To install a single EPA power adapter holder on a wall or ceiling:
NOTE:
This installation instruction procedure applies to the external power adapter.
You must order the mounting supplies for this installation separately. You need a drill and a pencil to complete this procedure.
1.
Install the EPA in the power adapter holder using Steps 1 through 3 in the
Power adapter holder assembly
section.
2.
Hold the EPA power adapter assembly to the wall or ceiling. Mark the screw-hole locations on the wall or ceiling with the
pencil.
3.
Drill four holes in the wall or ceiling at the pencil marks.
4.
Screw the power adapter holder assembly to the wall or ceiling using four screws.
Ceiling mount
46
External power adapter