Dell OptiPlex N Service Manual (.pdf) - Page 39
Table 3-2., System Error Messages, Controller has
![]() |
View all Dell OptiPlex N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Table 3-2. System Error Messages Message Definition Probable Causes Address mark not found BIOS found faulty disk sector or could not find particular disk sector. Faulty diskette/tape drive subsystem or hard-disk drive subsystem (defective system board). Attachment failed to respond Diskette drive or harddisk drive controller cannot send data to associated drive. Faulty interface cable or connector. Bad command or Command entered does Bad command. file name not exist or is not in pathname specified. Bad errorcorrection code(ECC) on disk read Diskette drive or harddisk drive controller detected uncorrectable read error. Faulty diskette/tape drive subsystem or hard-disk drive subsystem (defective system board). Controller has failed Data error Decreasing available memory Diskette drive 0 seek failure Diskette drive 1 seek failure Diskette read failure Hard-disk drive or associated controller defective. Computer received unrecoverable data-read error from diskette or hard-disk drive. Read/write failure during POST prevents computer from using available memory. Diskette/tape drive controller could not locate specific sector or track. Failure occurred while computer attempted to read diskette. Faulty diskette, diskette drive, or hard-disk drive. One or more DIMMs faulty or improperly seated. Faulty or improperly inserted diskette, incorrect configuration settings in System Setup program, loose diskette/ tape drive interface cable, or loose power cable. Faulty diskette, faulty or improperly connected diskette/tape drive interface cable, or loose power cable. Beep Codes and Error Messages 3-5
![](/manual_guide/products/dell-optiplex-n-service-manual-pdf-c2840ec/39.png)