Dell PowerConnect 6248 Command Line Interface Guide - Page 321

• leave - Indicates the time in centiseconds that the device waits before leaving its GARP state. • leaveall - Used to confirm the port within the VLAN. The time is the interval between messages sent, measured in centiseconds. • timer_value - Timer values in centiseconds. The range is 10-100 for join, 20-600 for leave, and 200-6000 for leaveall. Default Configuration The default timer values are as follows: • Join timer - 20 centiseconds • Leave timer - 60 centiseconds • Leaveall timer - 1000 centiseconds Command Mode Interface Configuration (Ethernet, Port-Channel) mode User Guidelines The following relationships for the various timer values must be maintained: • Leave time must be greater than or equal to three times the join time. • Leaveall time must be greater than the leave time. Set the same GARP timer values on all Layer 2-connected devices. If the GARP timers are set differently on Layer 2-connected devices, the GARP application will not operate successfully. The timer_value setting must be a multiple of 10. Example The following example sets the leave timer for port 1/g8 to 90 centiseconds. console (config)# interface ethernet 1/g8 console (config-if-1/g8)# garp timer leave 90 GVRP Commands 321