Dell PowerConnect 6248 Command Line Interface Guide - Page 950

Command Mode Router OSPFv3 Configuration mode. User Guidelines This command has no user guidelines. Example The following example enables administrative mode of OSPF in the router (active). console(config)#ipv6 router ospf console(config-rtr)#enable exit-overflow-interval Use the exit-overflow-interval command in Router OSPFv3 Configuration mode to configure the exit overflow interval for OSPF. It describes the number of seconds after entering Overflow state that a router will wait before attempting to leave the Overflow State. This allows the router to originate non-default AS-external-LSAs again. When set to 0, the router will not leave Overflow State until restarted. Syntax exit-overflow-interval seconds no exit-overflow-interval • seconds - Exit overflow interval for OSPF (Range: 0-2147483647) Default Configuration 0 is the default value for seconds. Command Mode Router OSPFv3 Configuration mode User Guidelines This command has no user guidelines. 950 OSPFv3 Commands