Dell PowerConnect B - MLXe 4 Hardware Installation Guide - Page 111
Managing Routers and Modules, Managing the device
View all Dell PowerConnect B - MLXe 4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
Chapter Managing Routers and Modules 5 Managing the device You can perform these management tasks for the router: • Display status and temperatures of all hardware components. • Display the Syslog configuration and static and dynamic buffers. • Disable and re-enable power to interface modules Disabling and re-enabling power to interface modules You can disable power and re-enable power to all interface modules. or to a specified interface module using the power-off command in the CLI, as shown in this example. PowerConnect# power-off lp all Syntax: power-off lp [all |] • all - disables power to all interface modules • - disables power to the interface module in the specified slot. You can specify 1-4 for 4-slot routers, 1-8 for 8-slot routers, and 1-16 for 16-slot routers. NOTE It is recommended that you do not disable power to interface modules during a software upgrade. If you try to disable power during a software upgrade, the following message will be displayed: Warning: There is an outstanding software download. Do you want to continue ? (enter "Y" or "n") Type "n" and wait until the upgrade is complete. To re-enable power to all interfaces. or to a specific interface, enter the power-on ip command, as shown in this example: PowerConnect# power-on ip Syntax: power-on lp [all |] • all - enables power to all interface modules • disables power to the interface module in the specified slot. You can specify 1-4 for 4-slot routers, 1-8 for 8-slot routers and 1-16 for 16-slot routers. PowerConnect B-MLXe Hardware Installation Guide 99 53-1002111-01