Dell PowerConnect Brocade M5424 Brocade 7.1.0 Fabric OS Command Reference Guid - Page 479
ifModeShow, ifmodeset eth0
View all Dell PowerConnect Brocade M5424 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 479 highlights
ifModeSet 2 EXAMPLES SEE ALSO --help Displays the command usage. To advertise all modes of operation, when not entering this command through the serial console port, follow this scenario for the ifModeSet command: switch:admin> ifmodeset eth0 Exercise care when using this command. Forcing the link to an operating mode not supported by the network equipment to which it is attached may result in an inability to communicate with the system through its ethernet interface. It is recommended that you only use this command from the serial console port. Are you sure you really want to do this? (yes, y, no, n): [no] y Proceed with caution. Auto-negotiate (yes, y, no, n): [no] y Advertise 100 Mbps / Full Duplex (yes, y, no, n): [yes] y Advertise 100 Mbps / Half Duplex (yes, y, no, n): [yes] y Advertise 10 Mbps / Full Duplex (yes, y, no, n): [yes] y Advertise 10 Mbps / Half Duplex (yes, y, no, n): [yes] y Committing configuration...done. To force the link for the eth0 interface from autonegotiation to 10 Mbps half-duplex operation, when entering this command through the serial console port: switch:admin> ifmodeset eth0 Auto-negotiate (yes, y, no, n): [yes] n Force 100 Mbps / Full Duplex (yes, y, no, n): [no] n Force 100 Mbps / Half Duplex (yes, y, no, n): [no] n Force 10 Mbps / Full Duplex (yes, y, no, n): [no] n Force 10 Mbps / Half Duplex (yes, y, no, n): [no] y Committing configuration...done. ifModeShow Fabric OS Command Reference 451 53-1002746-01