Dell PowerConnect Brocade M5424 Brocade 7.1.0 Fabric OS Command Reference Guid - Page 991
System Group Configuration Parameters, Security Level Parameters
View all Dell PowerConnect Brocade M5424 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 991 highlights
snmpConfig 2 3 Warning 4 Informational -mib_name mib_name Specifies the name of the MIB to be configured. This operand is required if you want to configure MIB traps noninteractively. Valid MIB names include the following. • FE-MIB • SW-MIB • FA-MIB • FICON-MIB • HA-MIB • FCIP-MIB • ISCSI-MIB • IF-MIB • BD-MIB -bitmask bit_mask Specifies the bit mask for the MIB. Refer to the table above for valid values. --enable mibCapability -mib_name mib_name Enables the specified MIB noninteractively. --disable mibCapability -mib_name mib_name Disables the specified MIB noninteractively. When used with the trap name operand, only the specified trap is disabled. -trap_name trap_name Specifies the name of the trap to be enabled or disable. This operand is optional. Use snmpConfig --show mibCapability for a listing of valid traps. System Group Configuration Parameters sysDescr The system description. The default value is Fibre Channel switch. sysLocation The location of the system (switch). The default value is End User Premise. The string must be at least 4 characters in length; the maximum length is 255 characters. sysContact The contact information for this system (switch). The default value is Field Support. Refer to the definition of sysDescr, sysLocation and sysContact in the system group of MIB-II. The string must be at least 4 characters in length; the maximum length is 255 characters. authTraps When enabled, the authentication trap (authenticationFailure) is transmitted to a configured trap recipient in the event that the agent receives a protocol message that is not properly authenticated. In the context of SNMPv1 and SNMPv2c, this means that a request contains a community string that is not known to the agent. The default value for this parameter is 0 (disabled). Security Level Parameters The --show option displays the current SNMP GET security and SNMP SET security levels. Use --set secLevel to modify existing settings: Fabric OS Command Reference 963 53-1002746-01