Dell PowerEdge 2800 Rack- to-Tower Conversion Guide - Page 18
Removing the Trim Panel
View all Dell PowerEdge 2800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
www.dell.com | support.dell.com Y1001bk0.book Page 16 Thursday, July 8, 2004 4:32 PM Removing the Trim Panel 1 Remove the trim panel. a Lay the system on its cover as shown in Figure 1-7. b Using a #2 Phillips screwdriver or 1/4-inch nut driver, remove the three screws from the side of the trim panel. See Figure 1-7. c Using a #2 Phillips screwdriver or 1/4-inch nut driver, remove the two screws from the back of the system. d Slide the trim panel backward and then remove the trim panel from the chassis. Figure 1-7. Removing the Trim Panel hex-head Phillips screws (2) hex-head Phillips screws (3) 2 Install the six shoulder nuts as shown in Figure 1-8. NOTE: Ensure that the shoulder nuts are tightened so that the shoulder of the nut is tight against the side. The system is ready to install in the rack. 16 Tower-to-Rack and Rack-to-Tower Conversion Guide