Dell PowerEdge M520 Dell 10Gb Ethernet Pass Through II for M1000e Software Use - Page 12

Rev 1.00 3 Command Line Interface (CLI) Reference Software User's Manual 10GbE PTM management is done via the 10GbE PTM CLI. You can use the commands described in this section after successfully connecting to the 10GbE PTM CLI according to the procedure described in Section 2, "Connecting to the 10GbE PTM CLI," on page 8. 3.1 CLI Privilege Levels The 10GbE PTM supports the following user privilege levels: • USER - Common user level, indicated by the # prompt • ADMIN - Administrator level, indicated by the & prompt Different commands are available in different privilege levels. The command reference indicates the required privilege level for each command that requires a privilege level higher than USER. 3.2 Quick Reference Table 5 provides a quick reference to the CLI commands: Table 5 - List of Commands Command name Short Description Reference General Commands help Shows the list of available commands Section 3.4.1, "help," on page 13 exit Exit from the 10GbE PTM CLI Section 3.4.2, "exit," on page 14 login Change privilege level Section 3.4.3, "login (ADMIN)," on page 14 Software Image Commands show image ver Shows the software image version Section 3.5.1, "show image ver," on page 14 copy image from-file Upload new software image to the 10GbE PTM Section 3.5.2, "copy image from-file," on page 15 Device Commands show device temp Shows the temperature of a specified device Section 3.6.1, "show device temp (ADMIN)," on page 15 Port Commands show port link Shows port link state Section 3.7.1, "show port link," on page 16 12