Dell PowerEdge M520 Dell 10Gb Ethernet Pass Through II for M1000e Software Use - Page 15

Dell 10Gb Ethernet Pass Through II # login admin & show image ver Software image version: X.X.XXX- Component #1 firmware version: Y.Y.YYY Component #2 firmware version: Y.Y.YYY Component #3 firmware version: Y.Y.YYY & login user Rev 1.00 3.5.2 copy image from-file Synopsis: copy image from-file [device_number] Description: Update the firmware on the 10GbE PTM. Immediately after running this command, the CLI waits for the user to send the firmware image using the ZModem protocol. To abort this operation, use CTRL-C. For additional details on the firmware update procedure refer to Section 4, "Operating Procedures," on page 19. ADMIN: device_number: When this option is specified, the command will update the firmware of a single PhyX® device, or the micro-controller software. This option specifies the device onto which to upload the image (0..3, where 0 indicates micro-controller image) Example: # copy image from-file # login admin & copy image from-file 2# Update image on device no. 2 & login user # 3.6 Device Commands 3.6.1 show device temp (ADMIN) Synopsis: show device temp device_number Description: Show the temperature of the specified device: >device_number: device number from which to read temperature (1..3) Example: & show device temp 1 Device no. 1 temperature: 42 [Celsius] & 15