Dell PowerEdge M520 Dell 10Gb Ethernet Pass Through II for M1000e Software Use - Page 7

Dell 10Gb Ethernet Pass Through II Rev 1.00 Condition Link up Data activity Link protocol mismatch Table 3 - LED Behavior Green LED Amber LED Description on off Both the internal and external links are up on blink Link is up and data packets are sent or received off on Refer to Section 1.3, "Link Protocol Mismatch Condition," on page 5 for details. 1.5 10GbE PTM Status Lights The 10GbE PTM Status lights indicate whether the switch is receiving power from the chassis, and the state of the 10GbE PTM. Figure 3: Indicator LEDs The I/O Module is on and ready when both the blue and green LEDs are lit. This LED can be blue or amber. A fault is indicated when the amber LED is blinking. See Table 4. Table 4 - 10GbE PTM states and LED configurations: Indication LED Green OFF Status OFF 10GbE PTM Status OFF Blinking Blue ON OFF Boot in Progress 10GbE PTM not ready ON BLINKING BLUE The CMC is identifying the newly installed 10GbE PTM ON ON BLUE 10GbE PTM is on and operating Nor- mally ON ON or BLINKING AMBER Fault in System Self-diagnosed OFF ON or BLINKING AMBER Fault in System CMC-detected 7