Dell PowerEdge M520 Dell 10Gb Ethernet Pass Through II for M1000e Software Use - Page 4

Rev 1.00 About this Manual Software User's Manual This manual describes the installation and basic use of the Dell 10Gb Ethernet Pass Through II for M1000e. Intended Audience This manual is intended for users and system administrators responsible for installing and setting up the I/O module. Related Documentation Additional documentation available is provided in Table 1. Table 1 - Referenced Documents Firmware Releases http://support.dell.com/support/ Terms, Abbreviations and Conventions Table 2 - Abbreviations and Convention Term Definition IOM PTM Downlink Uplink SSH CMC Component Component numbering I/O Module Pass Through Module Internal link - from servers to 10GbE PTM PHY (through the mid plane connector) External link - from 10GbE PTM PHY to external link (typically connected to Ethernet switch) Secure Shell (also refers to a software program that allows connectivity using an SSH protocol.) Chassis Management Controller 10GbE PTM PHY device Components are numbered from one (1) to three (3). When looking at the 10GbE PTM component side with external connectors (uplink) up, the components are numbered as follows: Device number 1 is the right-most component Device number 2 is the middle component Device number 3 is the left-most component Wherever applicable, device number 0 refers to the on-board micro-controller 4