Dell PowerEdge M520 Dell 10Gb Ethernet Pass Through II for M1000e Software Use - Page 24

Updating Firmware for a Single PhyX Device

Get Dell PowerEdge M520 PDF manuals and user guides View all Dell PowerEdge M520 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

Rev 1.00 Software User's Manual # exit Step 5. Power cycle the 10GbE PTM for the firmware to take effect. From the CMC command line type the following command: $ racadm chassisaction -m switch- powercycle Step 6. Wait for 20 seconds, and then connect to the 10GbE PTM. Run: $ connect switch- Step 7. Login to the 10GbE PTM command line interface as admin. Run: # login admin Step 8. To confirm that all three PhyX chips have the same firmware version, run the command: & show image ver Software image version: 1.0.28-201005131448-62 Component #1 FW version: 8.2.958 Component #2 FW version: 8.2.958 Component #3 FW version: 8.2.958 & 4.3.2 Updating Firmware for a Single PhyX Device Step 1. Connect to the 10GbE PTM. Run: $ Connect switch- Where n is the number of the switch, 2 in our example. Step 2. To start the upgrade process for a single PhyX device (1,2, or 3), run the command: # copy image from-file [device number] The system is now waiting for the file to be transferred from the SSH client. To complete the procedure, please follow Step 3 through Step 8 as described in Section 4.3.1 above. 24

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
Software User’s Manual
Rev 1.00
24
# exit
Step 5.
Power cycle the 10GbE PTM for the firmware to take effect. From the CMC command
line type the following command:
$ racadm chassisaction -m switch-<n> powercycle
Step 6.
Wait for 20 seconds, and then connect to the 10GbE PTM. Run:
$ connect switch-<n>
Step 7.
Login to the 10GbE PTM command line interface as admin. Run:
# login admin
Step 8.
To confirm that all three PhyX chips have the same firmware version, run the command:
& show image ver
Software image version: 1.0.28-201005131448-62
Component #1 FW version: 8.2.958
Component #2 FW version: 8.2.958
Component #3 FW version: 8.2.958
&
4.3.2
Updating Firmware for a Single PhyX Device
Step 1.
Connect to the 10GbE PTM. Run:
$ Connect switch-<n>
Where n is the number of the switch, 2 in our example.
Step 2.
To start the upgrade process for a single PhyX device (1,2, or 3), run the command:
# copy image from-file [device number]
The system is now waiting for the file to be transferred from the SSH client.
To complete the procedure, please follow Step 3 through Step 8 as described in
Section 4.3.1
above.