Dell PowerEdge SC1430 Hardware Owner's Manual - Page 24
Check the Time and Date settings. See, Update the BIOS firmware. See Getting - partition
View all Dell PowerEdge SC1430 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Table 1-6. System Messages (continued) Message Causes Corrective Actions The amount of system memory has changed Memory has been added or removed or a memory module may be faulty. If memory has been added or removed, this message is informative and can be ignored. If memory has not been added or removed, check the SEL to determine if single-bit or multi-bit errors were detected and replace the faulty memory module. See "Troubleshooting System Memory" on page 103. The following DIMM pair is not compatible with the memory controller: DIMM x and DIMM y The specified DIMM(s) are incompatible with the system. Ensure that only Dell-qualified memory is used. Dell recommends purchasing memory upgrade kits directly from www.dell.com or your Dell sales agent to ensure compatibility. The following DIMMs are The specified DIMM(s) are not compatible: DIMM x and incompatible with the system. DIMM y Ensure that only ECC FBD1 memory is used. Dell recommends purchasing memory upgrade kits directly from www.dell.com or your Dell sales agent to ensure compatibility. Time-of-day clock stopped Faulty battery or faulty chip. See "Troubleshooting the System Battery" on page 102. Time-of-day not set please run SETUP program Incorrect Time or Date settings; faulty Check the Time and Date settings. See system battery. "Using the System Setup Program" on page 27. If the problem persists, replace the system battery. See "System Battery" on page 79. Timer chip counter 2 failed Faulty system board. See "Getting Help" on page 123. Unsupported CPU combination Unsupported CPU stepping detected Microprocessor(s) is not supported by Install a supported microprocessor or the system. microprocessor combination. See "Microprocessor" on page 73. Utility partition not available The key was pressed during POST, but no utility partition exists on the boot hard drive. Create a utility partition on the boot hard drive. See the CDs that came with your system. Warning! No microcode update loaded for processor n Microcode update failed. Update the BIOS firmware. See "Getting Help" on page 123. 24 About Your System