Dell PowerSwitch S4128F-ON EMC SmartFabric OS10 User Guide Release 10.5.0 - Page 169

Supported Releases 10.4.1.0 or later Example: Configure SNMP This example shows how to configure SNMP on the switch, including SNMP engine ID, views, groups, and users. OS10(config)# snmp-server contact "Contact Support" OS10(config)# snmp-server engineID remote 192.168.1.2 udp-port 502 0xdefa OS10(config)# snmp-server engineID local test OS10(config)# snmp-server group sngroup 2c notify notofy_view OS10(config)# snmp-server group snv3group 3 noauth read read_view OS10(config)# snmp-server user snuser sngroup 3 auth sha a2FubmFuX3Rlc3Q= OS10(config)# snmp-server view readview 1.3.6.1.2.1.2.2 included OS10(config)# snmp-server view snview .1 excluded OS10(config)# do show snmp engineID local Local default SNMP engineID: 0x800002a20474657374 OS10(config)# do show snmp engineID remote Remote Engine ID IP-addr Port 0xdefa 192.168.1.2 502 OS10(config)# do show snmp group groupname : sngroup version : 2c notifyview : notofy_view groupname version security level readview : snv3group : 3 : noauth : read_view OS10(config)# do show snmp user User name : snuser Group : sngroup Version : 3 Authentication Protocol : SHA OS10(config)# do show snmp view view name : readview OID : 1.3.6.1.2.1.2.2 included : True view name OID excluded : snview : .1 : True System clock OS10 uses the Network Time Protocol (NTP) to synchronize the system clock with a time-serving host. When you enable NTP, it overwrites the system time. If you do not use NTP, set the system time and time zone after you disable NTP. Use the clock set command to set the current system time and date. The hardware-based real-clock time (RTC) resets to the new system time. Some geographical locations in the world observe the daylight savings time (DST) during summer months. To configure DST, use the clock timezone {standard-timezone standard-timezone-name | {timezone-string Hours Minutes}} command. OS10 supports the DST feature only for standard time zones. OS10 offers the user-defined time zone configuration only for backward compatibility. If you choose to configure a user-defined time zone, you must configure the hour and minute offset from UTC. User-defined time zones do not support DST. NOTE: Dell EMC recommends configuring a standard time zone supported in Linux. Use the ? character for command completion to view a list of supported standard time zones. System management 169