Dell PowerSwitch S4128F-ON EMC SmartFabric OS10 User Guide Release 10.5.0 - Page 597

• summary-only - (Optional) Filters more specific routes from updates. • advertise-map map-name - (Optional) Enter the map name to advertise. • attribute-map route-map-name - (Optional) Enter the route-map name to set aggregate attributes. • suppress-map route-map-name - (Optional) Enter the route-map name to conditionally filter specific routes from updates. Default None Command Mode ROUTER-BGPv4-AF Usage Information At least one of the routes that is included in the aggregate address must be in the BGP routing table for the configured aggregate to become active. If routes within the aggregate are constantly changing, do not add the as-set parameter to the aggregate because the aggregate flaps to track changes in the AS_PATH. The no version of this command disables the aggregate-address configuration. Example OS10(conf-router-bgpv4-af)# aggregate-address 6.1.0.0/16 summary-only Supported Releases 10.3.0E or later allowas-in Configures the number of times the local AS number can appear in the BGP AS_PATH path attribute before the switch rejects the route. Syntax allowas-in as-number Parameters as-number-Enter the number of occurrences for a local AS number, from 1 to 10. Default Disabled Command Mode ROUTER-BPG-NEIGHBOR-AF Usage Information Use this command to enable the BGP speaker to accept a route with the local AS number in updates received from a peer for the specified number of times. The no version of this command resets the value to the default. Example (IPv4) OS10(config-router-neighbor)# address-family ipv4 unicast OS10(conf-router-bgp-neighbor-af)# allowas-in 5 Example (IPv6) OS10(conf-router-template)# address-family ipv6 unicast OS10(conf-router-bgp-template-af)# allowas-in 5 Example (l2vpn) OS10(config-router-neighbor)# address-family l2vpn evpn OS10(config-router-bgp-neighbor-af)# allowas-in 3 Supported Releases 10.3.0E or later always-compare-med Compares MULTI_EXIT_DISC (MED) attributes in the paths that are received from different neighbors. Syntax always-compare-med Parameters None Default Disabled Command Mode ROUTER-BGP Usage Information After you use this command, use the clear ip bgp * command to recompute the best path. The no version of this command resets the value to the default. NOTE: To configure these settings for a nondefault VRF instance, first enter the ROUTER- CONFIG-VRF sub mode using the following commands: Layer 3 597