Dell PowerSwitch S4128F-ON EMC SmartFabric OS10 User Guide Release 10.5.0 - Page 568

ROUTE_REFRESH(2) CISCO_ROUTE_REFRESH(128) 4_OCTET_AS(65) Prefixes accepted 3, Prefixes advertised 0 Connections established 1; dropped 0 Last reset never For address family: IPv4 Unicast Allow local AS number 0 times in AS-PATH attribute Prefixes ignored due to: Martian address 0, Our own AS in AS-PATH 0 Invalid Nexthop 0, Invalid AS-PATH length 0 Wellknown community 0, Locally originated 0 For address family: IPv6 Unicast Allow local AS number 0 times in AS-PATH attribute Local host: 3.1.1.3, Local port: 58633 Foreign host: 3.1.1.1, Foreign port: 179 Verify neighbor fall-over on peer-group OS10# show running-configuration ! router bgp 102 ! address-family ipv4 unicast aggregate-address 6.1.0.0/16 ! neighbor 40.1.1.2 inherit template bgppg no shutdown ! neighbor 60.1.1.2 inherit template bgppg no shutdown ! neighbor 32.1.1.2 remote-as 100 no shutdown ! template bgppg fall-over remote-as 102 ! Configure password You can enable message digest 5 (MD5) authentication with a password on the TCP connection between two BGP neighbors. Configure the same password on both BGP peers. When you configure MD5 authentication between two BGP peers, each segment of the TCP connection is verified and the MD5 digest is checked on every segment sent on the TCP connection. Configuring a password for a neighbor establishes a new connection. NOTE: You can secure the VTEP neighbor communications as well using the MD5 authentication. Configure password • Configure the password in both the BGP peers in ROUTER-NEIGHBOR CONFIGURATION or ROUTER-TEMPLATE CONFIGURATION mode. The password provided in ROUTER-NEIGHBOR mode takes preference over the password in ROUTERTEMPLATE mode. Enter the password either as plain text or in encrypted format. ○ password {9 encrypted password-string|password-string} View password configuration • show configuration Peer 1 in ROUTER-NEIGHBOR mode OS10# configure terminal OS10(config)# interface ethernet 1/1/5 568 Layer 3