Dell PowerSwitch S4128F-ON EMC SmartFabric OS10 User Guide Release 10.5.0 - Page 670

3. Change the time interval, from 1 to 65535, that the router waits before declaring a neighbor dead in INTERFACE mode. The default time interval is 40. The dead interval must be four times the hello interval and must be the same on all routers in the OSPF network. ip ospf dead-interval seconds 4. Change the time interval between hello-packet transmission in INTERFACE mode, from 1 to 65535. The default time interval is 10. The hello interval must be the same on all routers in the OSPF network. ip ospf hello-interval seconds 5. Change the priority of the interface, which determines the DR for the OSPF broadcast network in INTERFACE mode, from 0 to 255. The default priority of the interface is 1. ip ospf priority number 6. Change the retransmission interval time, in seconds, between LSAs in INTERFACE mode, from 1 to 3600. The default retransmission interval time is 5. The retransmit interval must be the same on all routers in the OSPF network. ip ospf retransmit-interval seconds 7. Change the wait period between link state update packets sent out the interface in INTERFACE mode, from 1 to 3600. The default wait period is 1. The transmit delay must be the same on all routers in the OSPF network. ip ospf transmit-delay seconds Change parameters and view interface status OS10(conf-if-eth1/1/1)# ip ospf hello-interval 5 OS10(conf-if-eth1/1/1)# ip ospf dead-interval 20 OS10(conf-if-eth1/1/1)# ip ospf retransmit-interval 30 OS10(conf-if-eth1/1/1)# ip ospf transmit-delay 200 View OSPF interface configuration OS10(conf-if-eth1/1/1)# do show ip ospf interface ethernet1/1/1 is up, line protocol is up Internet Address 11.1.1.1/24, Area 0.0.0.0 Process ID 65535, Router ID 99.99.99.99, Network Type broadcast, Cost: 1 Transmit Delay is 200 sec, State BDR, Priority 1 Designated Router (ID) 150.1.1.1, Interface address 11.1.1.2 Backup Designated router (ID) 99.99.99.99, Interface address 11.1.1.1 Timer intervals configured, Hello 5, Dead 20, Wait 20, Retransmit 30 Neighbor Count is 1, Adjacent neighbor count is 1 Adjacent with neighbor 150.1.1.1(Designated Router) Redistribute routes Add routes from other routing instances or protocols to the OSPFv2 process and include BGP, static, or connected routes in the OSPFv2 process. Do not route IBGP routes to OSPFv2 unless there are route-maps associated with the OSPFv2 redistribution. NOTE: With the redistribute static command in the running configuration, if a static route is configured which is also learned through OSPF, even if the static route preference is higher than OSPF, the static route is installed in the routing table. • Enter which routes redistribute into the OSPFv2 process in ROUTER-OSPF mode. redistribute {bgp as-number| connected | static} [route-map map-name] ○ bgp | connected | static-Enter a keyword to redistribute those routes. ○ route-map map-name-Enter the name of a configured route map. Configure redistribute routes OS10(conf-router-ospf-10)# redistribute bgp 4 route-map aloha OS10(conf-router-ospf-10)# redistribute connected route-map aloha OS10(conf-router-ospf-10)# redistribute static route-map aloha 670 Layer 3