Dell PowerSwitch S4128F-ON EMC SmartFabric OS10 User Guide Release 10.5.0 - Page 255

Load balance traffic Use hashing to load balance traffic across member interfaces of a port-channel. Load balancing uses source and destination packet information to distribute traffic over multiple interfaces when transferring data to a destination. For packets without an L3 header, OS10 automatically uses the load-balancing mac-selection destination-mac command for hash algorithms by default. When you configure an IP and MAC hashing scheme at the same time, the MAC hashing scheme takes precedence over the IP hashing scheme. • Select one or more methods of load balancing and replace the default IP 4-tuple method of balancing traffic over a port-channel in CONFIGURATION mode. OS10(config)# load-balancing ingress-port Ingress port configurations tcp-udp-selection TCP-UDP port for load-balancing configurations ip-selection IPV4 load-balancing configurations ipv6-selection IPV6 load-balancing configurations mac-selection MAC load-balancing configurations ○ ingress-port [enable] - Enables the ingress port configuration. ○ tcp-upd-selection [l4-destination-port | l4-source-port] - Uses the Layer 4 destination port or Layer 4 source port in the hash calculation. ○ ip-selection [destination-ip | source-ip | protocol | vlan-id | l4-destination-port | l4- source-port] - Uses the destination IP address, source IP address, protocol, VLAN ID, Layer 4 destination port or Layer 4 source port in the hash calculation. ○ ipv6-selection [destination-ip | source-ip | protocol | vlan-id | l4-destination-port | l4- source-port] - Uses the destination IPv6 address, source IPv6 address, protocol, VLAN ID, Layer 4 port or Layer 4 source port in the hash calculation. ○ mac-selection [destination-mac | source-mac] [ethertype | vlan-id] - Uses the destination MAC address or source MAC address, and ethertype, or VLAN ID in the hash calculation. Configure load balancing OS10(config)# load-balancing ip-selection destination-ip source-ip Change hash algorithm The load-balancing command selects the hash criteria applied to traffic load balancing on port-channels. If you do not obtain even traffic distribution, use the hash-algorithm command to select the hash scheme for LAG. Rotate or shift the L2-bit LAG hash until you achieve the desired traffic distribution. • Change the default (0) to another algorithm and apply it to LAG hashing in CONFIGURATION mode. hash-algorithm lag {crc | xor | random} Change hash algorithm OS10(config)# hash-algorithm lag crc Configure interface ranges Bulk interface configuration allows you to apply the same configuration to multiple physical or logical interfaces, or to display their current configuration. An interface range is a set of interfaces that you apply the same command to. You can use interface ranges for: • Ethernet physical interfaces • Port channels • VLAN interfaces A bulk configuration includes any non-existing interfaces in an interface range from the configuration. Interfaces 255