Dell PowerSwitch S4128F-ON EMC SmartFabric OS10 User Guide Release 10.5.0 - Page 981

Example OS10# disable OS10# disable 6 Supported Releases 10.4.3.0 or later enable Enables a specific privilege level. Syntax Parameters enable privilege-level • privilege-level-Enter the configured privilege level, from 0 to 15. Defaults 15 Command Mode Exec Usage Information Dell EMC Networking recommends configuring a password for privilege level 15 using the enable password command. If you do not configure a password for a level, you can switch to that level without entering a password, unless a password is configured for a highest intermediate level. If you configure a password for an intermediate level, enter that password when prompted. To access privilege level 15, you must configure the enable password command. If you do not configure a password for privilege level 15, you cannot enter level 15. For privilege levels 0 to 14, the enable password command is optional. Privilege levels inherit all permitted commands from all lower levels. For example, if you log in to privilege level 10 using the enable 10 command, all commands that are assigned to privilege level 10 and lower are available for use. Example OS10# enable OS10# enable 10 Supported Releases 10.4.3.0 or later enable password priv-lvl Sets a password for a privilege level. Syntax Parameters enable password encryption-type password-string priv-lvl privilege-level • encryption-type - Enter the type of password encryption: ○ 0 - Use an unencrypted password. ○ sha-256 - Use a SHA-256 encrypted password. ○ sha-512 - Use a SHA-512 encrypted password. • priv-lvl privilege-level - Enter a privilege number from 1 to 15. Defaults Not configured Command Mode CONFIGURATION Usage Information To increase the required password strength, create stronger password rules using the password-attributes command. The no version of this command removes a privilege-level password. Security 981