Dell PowerSwitch S4128F-ON EMC SmartFabric OS10 User Guide Release 10.5.0 - Page 417

Example OS10(conf-if-po-10)# lacp max-bundle 10 Supported Releases 10.2.0E or later Lacp port-priority Sets the priority for the physical interfaces for LACP. Syntax lacp port-priority priority Parameters priority - Enter the priority for the physical interfaces (0 to 65535). Default 32768 Command Mode INTERFACE Usage Information LACP uses the port priority with the port number to create the port identifier. The port priority decides which ports are put into Standby mode when there is a hardware limitation that prevents all compatible ports from aggregating, or when you have up to 32 ports configured for the channel group. When setting the priority, a higher number means a lower priority. The no version of this command returns the port priority to the default value. Example OS10(conf-range-eth1/1/7-1/1/8)# lacp port-priority 32768 Supported Releases 10.2.0E or later lacp rate Sets the rate at which LACP sends control packets. Syntax Parameters lacp rate {fast | normal} • fast - Enter the fast rate of 1 second. • normal - Enter the default rate of 30 seconds. Default 30 seconds Command Mode INTERFACE Usage Information Change the LACP timer rate to modify the duration of the LACP timeout. The no version of this command resets the rate to the default value. Example OS10(conf-range-eth1/1/7-1/1/8)# lacp rate fast Supported Releases 10.2.0E or later lacp system-priority Sets the system priority of the device for LACP. Parameters priority - Enter the priority value for physical interfaces (0 to 65535). Default 32768 Command Mode CONFIGURATION Usage Information Each device that runs LACP has an LACP system priority value. LACP uses the system priority with the MAC address to form the system ID and also during negotiation with other systems. The system ID is unique for each device. The no version of this command resets the system priority to the default value. Example OS10(config)# lacp system-priority 32768 Layer 2 417