Dell S4148U-ON EMC Networking OS10EE FCoE Deployment with FSB - Page 27

7 7.1 7.2 S5248-ON FSB validation After configuring connected devices, many commands are available to validate the network configuration. This section provides a list of the most common commands and their output for this topology. Note: The following commands and outputs that are shown are for the S5248F-Leaf1. The output for the S5248U-Leaf2 is similar. For additional commands and outputs related to the leaf-spine portion of the topology, such as VLT, and BGP, see Dell EMC Networking Layer 3 Leaf-Spine Deployment and Best Practices with OS10EE. show interface status The show interface status | grep up command is used to verify required interfaces are up, and links are established at their appropriate speeds. S5248-Leaf1# show interface status | grep up Port Description Status Speed Eth 1/1/31 Server 1 up 10G Eth 1/1/32 Server 2 up 10G Eth 1/1/33 Server 3 up 10G Eth 1/1/34 Server 4 up 10G Eth 1/1/41:1 S4148U-F_Port.. up 10G Eth 1/1/53 Z9264F-Spine1.. up 100G Eth 1/1/54 Z9264F-Spine2.. up 100G Eth 1/1/55 VLTi up 100G Eth 1/1/56 VLTi up 100G Duplex full full full full full full full full full Mode Vlan Tagged-Vlans T 1 1001,1612-1616 T 1 1001,1612-1616 T 1 1001,1612-1616 T 1 1001,1612-1616 T 1 1001 - show vlan The show vlan command is used to verify configured VLANs and the interfaces they are applied to. S5248-Leaf1# show vlan Codes: * - Default VLAN, M - Management VLAN, R - Remote Port Mirroring VLANs, @ - Attached to Virtual Network Q: A - Access (Untagged), T - Tagged NUM Status Description Q Ports * 1 Active A Eth1/1/1- 1/1/40,1/1/41:1,1/1/42:1,1/1/43:1,1/1/44:1,1/1/45-1/1/52 A Po1000 1001 Active T Eth1/1/31-1/1/34,1/1/41:1 1612 Active vMotion T Eth1/1/31-1/1/34 T Po1000 1613 Active vSAN T Eth1/1/31-1/1/34 T Po1000 1614 Active web T Eth1/1/31-1/1/34 T Po1000 1615 Active app T Eth1/1/31-1/1/34 T Po1000 1616 Active db T Eth1/1/31-1/1/34 T Po1000 4094 Active T Po1000 27 Dell EMC Networking OS10EE FCoE Deployment with FSB