Dell U2723QE Monitor Users Guide - Page 45
Connecting the Monitor for DPBS for the First Time, set USB-C Charging to On in Off Mode.
![]() |
View all Dell U2723QE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Connecting the Monitor for DPBS for the First Time USB-C Initial monitor power state(OFF) Initial system power state(OFF) USB-C For the first time setting up the DPBS function, please follow below steps: 1. Make sure both the PC and monitor is OFF. 2. Connect the USB-C cable from the PC to the monitor. 3. Press the monitor power button to turn ON the monitor. 4. Both the monitor and PC will turn ON momentarily. Wait for a while (approximately 6 seconds) and both the PC and monitor will turn OFF. 5. Press either the monitor power button or PC power button, both the PC and monitor will turn ON. The PC system power state is in sync with the monitor power button. NOTE: When the monitor and PC are both at power OFF state at first time, it is recommended that you turn ON the monitor first, then connect the USB-C cable from the PC to the monitor. NOTE: You can power the OptiPlex 7090/3090 Ultra platform using its DC adaptor jack. Alternatively, you can power the OptiPlex 7090/3090 Ultra platform using the monitor's USB-C cable via Power Delivery (PD); please set USB-C Charging to On in Off Mode. Setting Up the Monitor | 45
![](/manual_guide/products/dell-u2723qe-monitor-users-guide-846207c/45.png)